Heated Bed Power Expansion Module Hot bed Module High Power Module MOS Tube

SKUMOS25
Heated Bed Power Expansion Module Hot bed Module High Power Module MOS Tube

Overview

Heated Bed Power Expansion Module Hot bed Module High Power Module MOS Tube

The module can be stable long-term work when measured I (Max) = 25A. When using the module, the current should not exceed 25A. Tip: When using hot bed power greater than 150W, an external high power module is needed.

Mounting holes:3.2mm diameter, for M3 screws
DCIN: "+" connect the power positive electrode: "-"connect the power negative, electrode(support "+ 12 v"or "+ 24 v" power supply, it is recommended to use + 24 v power supply)
Heatbed: connect to heatbed line(there are no positive or negative)
Connect the heatbed control port on the motherboard(there are no positive or negative)

1.When you connect power supply cable, you need to pay attention to distinguish the positive and negative polarity of the power supply,and do not reverse the connection of the cable to avoid burning the module and causing unnecessary losses
2.Module placement problem: when you use the module, do not put it in a place where the wires are dense. In this way, it helps to reduce the heating burden on the module and increase the safety
3.When the module is working: don't let the conductor to touch its bottom, it can prevent short circuit and burn out

in price  : 1pcs Heated Bed Power Module + 1pcs Connection cable for input signal + 2pcs Power Connection Cables
Maximum drive current: 25a
Weight 60g
  • Heated Bed Power Expansion Module Hot bed Module High Power Module MOS Tube
  • Heated Bed Power Expansion Module Hot bed Module High Power Module MOS Tube
  • Heated Bed Power Expansion Module Hot bed Module High Power Module MOS Tube
€6
€10
MOS25
available: Only 1 left in stock
waiting to send 5-10 days: Out of stock
waiting to send 25-40 days: Out of stock
Customer reviews and ratings

Be the first to write a review of this product!