RepRapDiscount Smart LCD Controller Support for Prusa i3

thing85644
Out of stock
€6.72 ×

RepRapDiscount Smart LCD Controller Support for Prusa i3

Not found the desired part? Order our 3D printing! This!

Included in the price:
printed parts

RepRapDiscount Smart LCD Controller Support for Prusa i3 - 1 pcs


Description from the site http://www.thingiverse.com/

UPDATE
The official LCD support for the original Josef Prusa i3 kit (not MK2)!

This is a RepRapDiscount Smart LCD Controller support originally designed for a Prusa i3 kit from Voxel Factory (an EiNSTeiN variant of the 3D printer).

The threaded rods are 10mm, don't hesitate to ask for a custom bracket.

The good news (or bad) is that there is no other material than plastic.

Show your make and remix please...

Instructions

See Prusa i3 Plus kit assembly - 6. LCD for a complete visual assembly guide.

You'll need to extend the ribbon cables before installing the LCD at the front of the printer. Right now, the cables I'm using are 60cm long each, the panel is still functionnal.

Slide the brackets on each side of the printed circuit board (PCB) on the rear side, open holes faceup. Insert the PCB into the cover while aligning the brackets with the slots. The inside of the slots and the surfaces of the brackets must to be clean.

The brackets then snaps on the threaded rods at the front of the Y carriage.


Description from the site http://www.thingiverse.com/
Material: ABS + normalization
Bearings support: LM8UU x 1 pcs
license compliance
Creative Commons - Attribution - Share Alike license.
link to Licenses http://www.thingiverse.com/thing:85644/attribution_card


Worldwide delivery! paypal accepted. All our parcels with Track Number!

Delivery Slovak post to USA(Air with track number) about 6$
Delivery Slovak posta to EU (with track number) about 5$

Categories: Printed parts, Reprap parts

RepRapDiscount Smart LCD Controller Support for Prusa i3 reviews

Be the first to write a review of this product!

Real Time Web Analytics